Kinshi High Tech Sieve

The High Tech Kinshi Sieve pre-filter to filter waste solids from the water via a bottom drain or through a skimmer. This technique incorporates a sieve-bend. A sieve-bend consists of hundreds of sharp stainless steel profile wires with very small slot openings where the water can go through but the solids stay on the sieve bend. The water enters the High Tech Kinshi Sieve via the Ultraskim or bottom drain and passes through the “auto-adjustable” dam and will go upwards and fall over the weir on to the Stainless Steel sieve-bend. The water goes through the sieve bend and the waste solids will slowly go down to the waste area. At the waste outlet of the filter is a 1.5 inch ( 50 mm ) male thread with ball valve included to easily wash away the waste with water. When the water in the tank underneath the sieve-bend is not pumped away fast enough the water will raise which makes the floating system ( auto-adjustable dam ) go up to reduce the incoming water flow. The High Tech Kinshi Sieve has a floating system to prevent the water in the area under the sieve from rising above the level of the sieve for low speed pumps and also to prevent the water from going too low to be primed for high speed pumps. To remove the waste that is on the surface of the High Tech Kinshi Sieve is very easy by opening the waste outlet and to rinse the waste away with a normal hosepipe. Another method to have water run over the screen is pushing down the adjustable dam, which will flood the screen with water. When the adjustable dam is in a low position already because of the pump speed you can pull up the dam for a short while and push it back downwards again. To remove the waste that has gone into the profile wires of the High Tech Kinshi Sieve ( only when necessary ) you will need a hosepipe with a powerful spray nozzle or a high-pressure machine. For this way of cleaning you have to place the sieve in an upright position or take the sieve out of the unit. After a certain period of time the sieve can get “fat” and this will make it more difficult for the water to go through. You can clean the sieve with i.e. alcohol. Note: when you use the sieve for the very first time the surface of the sieve can also be covered with a very thin film. Make sure you clean the sieve very thorough with alcohol before using it. If you have any questions about the Kinshi High Tech Sieve Filters, please feel free to contact us.

Kinshi High Tech Sieves zijn voorfilters die worden gebruikt om grof vuil ( zoals bladeren, losse algen, voederresten etc. ) uit het water te verwijderen, voordat het in de biologische kringloop terecht komt. Hierdoor worden de bacteriën in de biologische filter minder sterk belast en blijft het water beter schoon. De Kinshi High-Tech Sieves worden het beste op een 1 skimmer en 1 bodemdrain aangesloten. Het water komt de filter binnen door 2 buizen met een diameter van 110 mm. Van hieruit loopt het water over de zeef gemaakt van roestvrij staal. De zeef bevat gaten die verlopen van 300 mircron naar 200 micron ( voldoende om het water door te laten en al het vuil tegen te houden ). Het water komt in de opvangbak terecht, van waaruit het door de pomp terug in de vijver of in de biologische filter kan worden gepompt. Door middel van een klep kan de watertoevoer worden onderbroken, zodat de zeef schoongemaakt kan worden. Het afval kan met weinig water uit het systeem worden gespoeld. De uitlaat voor het vuil kan ook op een riolering worden aangesloten. Als u vragen heeft over de Kinshi High Tech Sieve Filters, neem dan gerust contact met ons op.